Cable Connector Plates; Central Location Rear Connector Plates (Phases 1 And 2); Figure 11. Rear Connector Plate (845416585) And Locations (Phase 1) - AT&T System 85 Installation And Test

Note: It is recommended that the cabling and hardware additions be done during low
traffic times for minimum disruption to the customer, as the system will be down when
power is removed.
Cable Connector Plates
Central Location Rear Connector Plates (Phases 1 and 2)
At the rear of the central module control cabinet(s) associated with RMI, remove the
original blank plate(s) (844172304). Install the new rear connector plate(s) (845416585). The
connector plate(s) is required in the central module control cabinet for Phase 1 systems only.
Figure 11 is an example of the plate(s) and location(s). Two plates must be added for a
duplicated system, and only one plate (lower) is added for an unduplicated system.
Note: The 845416585 plate mounts only on R2 cabinet frames. If this is a retrofit R1
frame, use a standard R1 connector plate to accommodate at least one Amphenol
connector. It will be necessary to loosen several connector plates in order to remove the
blank plate(s) and install the new one(s). All plates should be secured to cabinet after
the new plates are in place.
CENTRAL MODULE
CONTROL CABINET
(REAR VIEW)
* FOR DUPLICATED SYSTEMS ONLY.
t FOR UNDUPLICATED AND
DUPLICATED SYSTEMS.
REM
DO
REAR CONNECTOR
BRACKET (845416585)
Figure 11. Rear Connector Plate (845416585) and Locations (Phase 1)
Page 18