Lexmark Optra E 4026-0 Series Reference Handbook page 18

User Error
Message
Data Transmission
Error
Flash Memory Full
POST Symptom Table
Symptom
POST completes except one or
more LEDs do not come on.
None of the LEDs come on.
The printer is dead (No LEDs
come on, no motor turns)
The fan does not come on.
The fuser lamp does not come on.
The polygon motor does not come
on.
The main drive motor does not
come on.
LED Status
Data, Error, and
Press Button on
solid
Error blinking and
Press Button on
solid
Action
Refer to the Operator Panel Service
Check in the Service Manual.
Refer to the Operator Panel Service
Check in the Service Manual.
Refer to the Low Voltage Power
Supply Service Check in the Service
Manual.
Refer to the Fan Service Check in the
Service Manual.
Refer to the Cold Fuser Service
Check in the Service Manual.
Replace the printhead assembly. If
this does not fix the problem, replace
the engine board.
Refer to the Main Drive Motor Service
Check in the Service Manual.
Action
Switch to Print Accelerator
using the Lexmark driver for
Windows if 2MB of memory
or more is installed, or
switch to the GL/2 printing
mode using the Lexmark
driver for Windows, or push
the operator panel button to
resume printing, or do a
front panel reset by pressing
and holding the operator
panel button for more than
three seconds.
This condition only occurs
when the Flash memory is
full.
4026-0XX
1-11