Lexmark Optra E 4026-0 Series Reference Handbook page 97

Error Message Table (Continued)
Error/Code
37 Insufficient
Memory
38 Memory Full
39 Complex Page
43 Font Card Not
Supported
44 Defective Font
Card
47 Font Card
Removed While
Printing
52 Flash Full
53 Unformatted or
Defective Flash
54 Serial Error
58 Duplex Not
Attached
59 Duplex Cover
Open
62 Disk Full
63 Unformatted or
defective Disk
5-4
Laser Printer Reference Handbook
Action
Not enough memory for function requested. To
verify that the printer recognizes all the installed
memory, go to "Print Tests" on page 5-18 and print
the test page. Make sure the memory shown on the
printout matches the installed memory.
Memory used to store pages is full. To verify that the
printer recognizes all the installed memory, go to
"Print Tests" on page 5-18 and print the test page.
Make sure the memory shown on the printout
matches the installed memory.
Page too complex to print. To verify that the printer
recognizes all the installed memory, go to "Print
Tests" on page 5-18 the user menus and print the
"Print Menus" test page. Make sure the memory
shown on the printout matches the installed
memory.
Font card format not supported by printer.
Defective font card installed in font slot.
Printer needs data on removed card.
Not enough flash memory for data requested to be
stored.
Flash problem at POR or while attempting to write.
Framing or parity error on serial.
Duplex is no longer connected, and printer top cover
is closed.
Top cover of duplex unit is sensed open.
Not enough disk space for data that has been
requested to be written to disk.
The printer will ignore a disk it senses as defective.
Run the Quick Disk Test. If the test fails, the disk is
defective or the data on track1 is bad. If the Quick
Disk Test passes but the disk does not work, run the
Disk Test/Clean (2 hr. test). Replace the disk as
instructed by the operator panel.