Table of Contents
Advertisement
36
Operation Section
Configuration Parameters
Table 2
Configuration Parameters
Engine Serial Number
Rating
Full Load Setting
Full Torque Setting
ECM Software Release Date
Customer Specified Parameters
Customer specified parameters allow the engine to
be configured to the exact needs of the application.
The electronic service tool is required to alter the
customer configuration parameters.
Customer parameters may be changed repeatedly as
operational requirements change.
Table 3
Specified Parameters
Top Engine Limit
Low Idle Speed
Top Engine Limit
Engine Acceleration Rate
Engine Speed Decelerating Ramp Rate
Ether Start Aid Configuration
Crankcase Pressure Sensor Installation Status
Ambient Air Temperature Sensor Installation Status
Engine Idle Shutdown Enable Status
Engine Idle Shutdown Delay Time
Engine Idle Shutdown Ambient Temperature Override Enable Status
Delayed Engine Shutdown Enable Status
Delayed Engine Shutdown Maximum Time
Engine Performance Run Out Control Configuration
Engine Governor Mode Override Switch Installation Status
Transmission Default Torque Limit Reset
Air Filter Restriction Switch Installation Status
Air Filter Restriction Switch Configuration
System Configuration Parameters
Customer Specified Parameters
Record
Record
1900 rpm
600 rpm
2090 rpm
2000 rpm/s
2000rpm/s
Not Installed
Not Installed
Not Installed
Disabled
5.0 min
Disabled or Not Installed
Disabled
7.0 min
Not Installed
Not Installed
Not Reset
Not Installed
Normally Open
M0109073
(continued)
Advertisement
Table of Contents
