Mircom OpenBAS-HV-NX10 Series Installation Manual page 4

Figure 1 Parts of the enclosure ....................................................................................................
Figure 2 Tabs on enclosure ..........................................................................................................
Figure 3 Lift tabs and remove circuit board ..................................................................................
Figure 4 Board connections .........................................................................................................
Figure 5 COM ports ......................................................................................................................
Figure 6 Location of factory-installed modules and jumpers ........................................................
Figure 7 The jumper and RS-485 module are removed from P1 .................................................
Figure 8 OpenBAS-ACC-RS232 is installed in P1 .......................................................................
Figure 9 I2C, I2CB, N2, and SPI connections ..............................................................................
Figure 10 DIP switches ..................................................................................................................
Figure 11 Enclosure (back view) ....................................................................................................
Figure 12 Fit the circuit board in enclosure ....................................................................................
Figure 13 Enclosure mounted on DIN rail (circuit board not shown) ..............................................
Figure 14 Enclosure mounted on DIN rail (back view) ...................................................................
Figure 15 Power supply - 24 VAC or 24 VDC ................................................................................
Figure 16 Power supply - 12 VDC ..................................................................................................
Figure 17 Universal Inputs .............................................................................................................
Figure 18 Measuring VDC ..............................................................................................................
Figure 19 Digital input voltage range ..............................................................................................
Figure 20 Analog outputs ...............................................................................................................
Figure 21 Relay outputs .................................................................................................................
Figure 22 Field bus connections ....................................................................................................
Figure 23 Networking with OpenBAS-NWK-ETH3 with the included cable ...................................
Figure 24 Networking with OpenBAS-NWK-ETH3 over RS-458 ....................................................
Figure 25 Networking with RS-485 .................................................................................................
Figure 26 Connections and LEDs on the OpenBAS-HV-NX10D ...................................................
Figure 27 LEDs ..............................................................................................................................
4 (45)
List of Figures
10
11
12
13
14
15
15
16
17
18
19
20
21
21
23
23
23
29
30
32
33
36
37
37
38
38
39