Mircom TX3-BBCX-4W Wiring

Hide thumbs Also See for TX3-BBCX-4W:

A complete library of product

information is available at:

www.TX3.mircom.com

MOUNT THE CARD ACCESS CONTROLLERS

1. Mount up to 4 card access controllers in the enclosure. Mount each card so that

the P7 LED display port is on the left.

2. Mount the cards in two layers using the stando s.

3. Connect the LED ribbon cables to the P7 LED display ports on the card access

controllers.

Figure 1.

Mounting the card access controllers

TX3-BBCX-4W Wiring

Printed in Canada

Subject to change without prior notice

LT-1182 rev 0

(

)

Table of Contents

Do you have a question about the TX3-BBCX-4W and is the answer not in the manual?

Page 1 TX3-BBCX-4W Wiring MOUNT THE CARD ACCESS CONTROLLERS 1. Mount up to 4 card access controllers in the enclosure. Mount each card so that the P7 LED display port is on the left. 2. Mount the cards in two layers using the stando s.
Page 2 Lower cards Figure 2. Wiring the card access controllers to the batteries A complete library of product © Mircom 2014 Printed in Canada information is available at: Subject to change without prior notice www.TX3.mircom.com LT-1182 rev 0...