Switch Settings - Toshiba V Series User Manual

Chapter 3 Preparing for Operation (Hardware)

3.2 Switch Settings

3
22
The EN311 provides two connected switches that are used to switch between 10BASE5
and 10BASE2 networks, i.e., to select the connected network type.
• The EN311 cannot be connected to both a 10BASE5 and a 10BASE2 network concurrently.
Do not connect a network cable of the unused type to the EN311. This can damage the
EN311 or cause it to malfunction.
• Do not change this switch setting while a data transfer is in progress. This can damage the
EN311 or cause it to malfunction.
• When changing this switch setting, turn both switches together at the same time. Only turn-
ing one of the switches at a time will not result in normal correct switching between the net-
works.
(1) 10BASE5
Turning the two connected DIP switches on the front panel to the left allows a
10BASE5 network to be connected.
Figure 3-2 Switch Settings when a 10BASE5 Network is Used (front view)
(2) 10BASE2
Turning the two connected DIP switches on the front panel to the right allows a
10BASE2 network to be connected.
Figure 3-3 Switch Settings when a 10BASE2 Network is Used (front view)
Caution
10BASE5 10BASE2
10BASE5 10BASE2
Ethernet module User's Manual