Toshiba V Series User Manual page 66

Chapter 4 Preparing for Operation (Software)
4
46
Error Code
LAN controller driver 90H
error
91H
92H
Memory pool allocation A0H
failure
Port 2 task start failure A1H
Broadcast specification A2H
error
MAC address B0H
specification error
B1H
Insufficient resources C0H
error
Error in (number of C1H
words) receive request
from S3
C2H
Send buffer full C3H
Remote station window C4H
size is too small
Table 4-3 Detailed Information
Occurs if the setting of the local station IP address/port
number in the area reserved for transmission fails.
• Error in the TCP or UDP protocol (such as a transmission
phase error)
• Due to the remote-station down, the TCP socket made
the request to send to the socket where the NOACK bit of
the socket status is ON.
• Occurs if the setting of the remote station IP address in
the remote station information area (the NETDATA table)
fails.
• Occurs if the remote station IP address network address
differs from the local station IP address network address.
Occurs if the EN311 internal OS fails to allocate memory.
Occurs if computer link/PC link socket identifier acquisition
fails.
Occurs if the remote IP address is broadcasted on a remote
station verification request.
BCC error
Occurs if an error occurs after address saving on a MAC
setup request.
• Occurs if a transmission is repeated with cycle less than
100 ms to a non-existent remote station for UDP send/
PC link transmission.
• The UDP socket made the request to send when the
buffer in the EN311 was full without taking the received
data over to the S3 side.
The size specified by the user program is less than the size
of data, which EN311 has received.
The size specified by the user program is out of the range
(1-1000 words).
In the TCP socket transmission, the remaining space of the
send buffer of the corresponding socket to which the send
request data is stored is less than the data size of send
request.
In the TCP socket transmission, the window size of the
remote station ACK is smaller than the data size of send
request.
Description
Ethernet module User's Manual