4.9 Initialization Sample Program
This section describes the sample program that puts the EN311 into a run mode. After
the EN311 enters the run mode, it becomes possible to use the slave station functions of
the computer link/PC link.
Sample program specification: EN311 is installed into Slot 6 on the base.
Local IP address: 133.113.90.10
Local message transfer UDP port number: 2000
6F8C0904
Start
Read the station status
N
Run mode ?
Y
Issue the operating mode control
request(stand by)
Issue the reset request
Issue the parameter setup request
Issue the operating mode control
request(run)
Read the station status
N
Requested operating mode?
Y
End
4.9 Initialization Sample Program
7EFFH on DPRAM(word address)
(If the result of ANDing with
1000H is 1000H)
4
57