Toshiba V Series User Manual page 238

Appendix C Error Status Table
C
218
Table C-1 Contents of Completion Statuses
STATUS Name
0BxxH Transmission error
Error Code
Normal 01H
completion
Local station fault 02H
Local station 03H
standby
Timeout 20H
Length error 30H
Station mode 40H
error
MAC/IP not set up 50H
Transmission 60H
prohibited state
Format error 70H
71H
72H
73H
75H
77H
Opened 80H
Unopened 81H
Incorrect socket 82H
identifier
Incorrect control 83H
request
specification
• Occurs if the EN311 detects an error and responds.
For more information, see Table C.2 below.
Table C-2 Detailed Information
Description
The local station is in down mode
Data transmission in standby mode was requested.
Timeout occurred during TCP open processing or receive
processing, or during UDP receive processing.
Incorrect transmission data length
One of the following requests was issued in a mode other than
standby mode:
a. Parameter setup,b. MAC address setup,c. Reset
Occurs if the MAC address or IP address is not set up.
• Occurs if a PC link request was issued in run mode in the mes-
sage transmission prohibited state.
• Occurs if a socket open, close, send, or receive request is
issued in run mode in the socket interface transmission prohib-
ited state.
Occurs when there is a format error in the request text.
Port number error/IP address error
Request code error
Time setting: Year
Time setting: Day
Time setting: Minute
Occurs if an open request is issued for an already open socket.
• Occurs if send, receive, or close request is issued for an
unopened socket.
• The TCP socket was used to make the transmit/receive request
to the socket that is receiving CLOSE from the remote station.
Occurs if the socket identifier is out of range (1 to 8).
Occurs if a request that was prohibited by an operating mode
control request is issued.
• Occurs if a run request is issued in run mode.
• Occurs if a standby request is issued in standby mode.
• Occurs if a run request and a standby request are issued at the
same time.
Explanation
74 Time setting: Month
H
76 Time setting: Hour
H
78 Time setting: Second
H
Ethernet module User's Manual