B Socket Service Command Table - Toshiba V Series User Manual

Appendix B Socket Service
The following table lists the socket service commands used with USEND_T/URCV_T
instructions sent to the EN311. Refer to the section/item indicated in the reference
column in the table for detailed explanations of the request codes.
Command/Code
Reset request/16#0311 Resets the module.
Parameter setup
request/16#0312
Operating mode control
request/16#0313
Remote station
verification request/
16#0314
RAS information
readout request/
16#0315
Time set request/
16#0318
Register read request
(PC link function)/
16#0321
Register write request
(PC link function)/
16#0321
UDP open request/
16#0331
UDP send request/
16#0332
UDP receive request/
16#0333
UDP close request/
16#0334
TCP open request/
16#0335
TCP send request/
16#0337
TCP receive request/
16#0338
TCP close request/
16#0339
6F8C0904
Command Table
Table B-1 Request Codes to the EN311
Function
Sets up the EN311 parameters. USEND_T
Sets the operating mode.
Verifies the existence of
another node on the network.
Reads out the module RAS
information.
Sets the module internal clock
Time information for event trace
Reads register data from
remote station into registers in
the local station.
Writes register data from the
local station to registers in
remote station.
Opens a UDP socket.
Transmits data from a UDP
socket.
Reads out data received by a
UDP socket.
Closes (terminates) a UDP
socket.
Opens a TCP socket.
Transmits data from a TCP
socket.
Reads out data received by a
TCP socket.
Closes (terminates) a TCP
socket.
Instruction Class Reference
USEND_T (1) Section 4.3
(1) Section 4.4
USEND_T (1) Section 4.5
USEND_T (1) Section 7.3
URCV_T (1) Section 7.5
USEND_T (1) Section 7.4
URCV_T (2) Section 5.4
USEND_T (2) Section 5.3
USEND_T (3) Section 6.4.1
USEND_T (3) Section 6.4.2
URCV_T (3) Section 6.4.3
USEND_T (3) Section 6.4.4
USEND_T (3) Section 6.4.5
USEND_T (3) Section 6.4.6
URCV_T (3) Section 6.4.7
USEND_T (3) Section 6.4.8
215