Table of Contents
Advertisement
Helix M1100 Q4 Mobile
Multiple Helixes (Wireless DMX Control)
You can use the Helix in a wireless DMX setup. Make sure the device is operating in wireless DMX mode,
which can be set in the main menu (see 6.8.1.3. DMX Signal on page 34 for more information).
Sweden 2.4GHz Wireless Communication Module
Communication distance:
Test conditions:
Range indoor:
Range outdoor:
Wireless DMX Connection
The wireless receiving module "Nano G5 Receiver, 2.4GHz", provided by Swedish WIRELESS SOLUTION,
only has a 2.4 GHz wireless signal receiving function. In order to establish a wireless connection, please
use the (52001) W-DMX BlackBox F-1 Tranceiver G6 by WIRELESS SOLUTION. To control the status of the
wireless communication, please look at the green LED indicator light on the right-hand side of the display.
Note:
●
When the Helix receives a wireless DMX signal, then this signal will also be present at its 5-pin DMX
output (05). However, the Helix has not been designed to send wireless signals. Therefore, always
connect the Helix devices to each other using a DMX cable.
Wireless DMX Problems
01) No signal from the W-DMX transmitter.
The LED indicator will blink quickly.
02) Proper connection with the W-DMX transmitter, but no DMX signal is present.
The LED indicator will blink slowly.
When the wireless DMX communication is unhindered and a DMX signal is present, the LED indicator will
always be on.
Note:
The Helix M1100 Q4 Mobile cannot receive a W-DMX signal and a DMX cable signal at the same time.
When the device is in Auto mode or Built-in Programs mode, please ensure that the paired 2.4GHz
wireless signal transmitter is OFF.
Note:
The Helix M1100 Q4 Mobile is only a W-DMX receiver and never a W-DMX transmitter.
Product code: 43750
depending on the transmitting power or transmitter module
W-DMX TRx Transmitter module, 2dBi Antenna, transmitting power
20dBm (100mW)
60 m (approx. through three concrete walls)
250 m
25
Advertisement
Table of Contents
