Wireless Connectivity
VFC400-WiFi User Guide
either of these access methods.
If you continue to get this error, please discuss this further with your network
administrator.
The VFC400-WiFi has successfully connected to the wireless network and is in
the process of connecting to the LogTag
If you see this icon on the display for more than 10 seconds, the VFC400-WiFi
has to try repeatedly to connect to the network.
If the connection eventually succeds, this could indicate a weak wireless signal,
or general network issues related to the new device. If possible, move the
logger closer to the access point and discuss this further with your network
administrator.
The VFC400-WiFi has successfully connected to the wireless network, but was
unable to establish a connection with the cloud server.
This can have a number of different reasons, which include the following:
No DHCP server found on the network
l
You may have set up the VFC400-WiFi to use DHCP, but your network
does not offer DHCP connections. Please discuss this with your network
administrator, and run the LogTag
selecting Advanced Setup.
No IP address or DNS server configured
l
Please re-run the LogTag
Setup and enter the correct DNS settings. If available, use DHCP to
receive the DNS settings.
®
The LogTag
Online cloud server is offline
l
If both wireless and cloud connection show success, yet you still do not receive
any data into your LogTag
Your device may be registered to a different team
l
Please re-run the LogTag
device to your team
Your device has no data to upload
l
The last Connection time should still be updated once you perform a
Connection Test
®
Online cloud server.
®
Online Connection Wizard again,
®
Online Connection Wizard, select Advanced
®
Online account, please check the following:
®
Online Connection Wizard and register the
23
Need help?
Do you have a question about the LogTag VFC400-WiFi and is the answer not in the manual?