Table of Contents
Advertisement
Preparing a VFC400-WiFi for first use
VFC400-WiFi User Guide
17
Adding the Sensor and the Power Supply
Before the VFC400-WiFi can record temperature data you will need to connect an external sensor.
The VFC400-WiFi accepts any ST100 sensor. Plug the sensor into the socket located at the bottom of the
device, as shown below.
For stationary applications we strongly recommend you connect a power
supply (see
Powering the
VFC400-WiFi).
Remove the protective cap and insert the USB connector.
Note that the wider part of the connector is oriented towards the rear of the
product.
Advertisement
Table of Contents
Need help?
Do you have a question about the LogTag VFC400-WiFi and is the answer not in the manual?