Preparing a VFC400-WiFi for first use
Configuring the VFC400-WiFi for logging
Before a VFC400-WiFi logger can be used, it must be configured with the parameters required for
starting and recording temperature values
l
triggering alarms
l
connecting to the local WiFi network
l
connecting to your cloud account
l
This is done using Control Solutions VTMC software, which can also be used for downloading and analyzing
data. Control Solutions VTMC includes the LogTag
wireless and network settings and register the VFC400-WiFi against your Control Solutions Online account.
Start the Control Solutions VTMC software.
l
Remove the protective cap from the logger's USB socket and plug the Micro USB end of the cable into
l
the socket. Plug the other end of the cable into a USB socket on your computer and wait for the drivers to
be installed.
Slot the logger into the interface, contacts facing down and towards the rear of the interface.
l
From the menu click LogTag - Configure; Control Solutions VTMC will display the contents of your
l
VFC400-WiFi for reviewing or editing configuration settings.
Standard Configuration Settings
The standard configuration is similar to those of other LogTag logger products and includes settings such as
User
ID,
start
method,
pre-start
Adjust the settings as required. For detailed information about each parameter please read the section about
Configuring a LogTag for logging in Control Solutions VTMC's User Guide or press F1 for help.
VFC400-WiFi User Guide
®
Online Connection Wizard, which will allow you to set
recording,
logging interval
and duration,
start
delay, and password.
10
Need help?
Do you have a question about the LogTag VFC400-WiFi and is the answer not in the manual?