Table of Contents
Advertisement
SD-Card
SD-Cards (up to 2GB only) are supported.
To access the SD-Card:
• Make sure that the instrument is disconnected and off.
• Use a screwdriver to unscrew the 6 screws of the battery compartment cover.
• Remove the cover and withdraw the battery from its compartment without disconnecting it.
• Press on the SD-Card to release it then press on the protecting tab to withdraw it from
its slot.
• When replacing the SD-Card, the contacts must be on the left side, and the locator down.
• Slide it into its slot until it snaps into place. The protecting tab is at the top of the card.
• Put the battery back in its compartment and screw the cover back on.
Getting Started
NOTE: Make sure the PowerPad
Connecting:
• Start the instrument by pressing the
• Configure the instrument to obtain the required results and type of network.
• Connect the current leads and sensors to the PowerPad
• Connect the ground and/or neutral lead to the network ground and/or neutral (when
distributed), as well as the corresponding current sensor.
• Connect the L1 phase lead to the network L1 phase, as well as the corresponding
current sensor.
• Repeat the procedure for phases L2, L3 and N.
Disconnecting:
• Proceed in the reverse order to connecting, always finishing by disconnecting the
ground and/or neutral (when distributed).
• Disconnect the leads and press the
• Recharge the battery, if necessary.
Installation of the Leads and Current Sensors
Color-coded ID markers are supplied with the PowerPad
• Detach the appropriate inserts from the color-coded marker and place them in the holes provided
under the terminals (larger inserts for current terminals, smaller inserts for voltage terminals).
• Clip the rings of the same color to the ends of the lead that will connect to the terminal.
N/D
N/D
Shop for AEMC products online at:
®
L3/C
L2/B
L1/A
L3/C
L2/B
L1/A
E/GN
ShopAEMC
www.
is fully charged before use.
button.
.
®
button to turn the instrument off.
to identify the leads and input terminals.
®
.ca
1.800.561.8187
Advertisement
Table of Contents
