Getting Started; Set-Up Mode - AEMC CA7027 User Manual

4.3
The instrument is switched on and off using the green power button
found on the lower right side of the front panel. When the unit is first switched
on it will display the opening screen giving the software version, the currently
selected Vp (Velocity of Propagation), cable impedance and battery status
indicator.
4.4
1. Hold down the

set-up mode.

2. The following options can be configured:
• TDR or Tone Generation
• Set Vp to % (1 to 99%) or speed in micro-seconds (see § 4.8)
• Set cable impedance (Z) to 25, 50, 75 or 100Ω Twisted pair (T/P)
• Set measurement units to Feet or Meters
• Adjust the display contrast
• Disable/Enable Auto-off function
3. Press the
4. Press the
5. Press the
NOTE: When the Fault Mapper Pro
current set-up parameters.
Fault Mapper Pro
uality Products Online at:

Getting Started

Set-up Mode
TDR /
>
button to move the line selector (>) down the screen.
TEST /
and buttons to change the setting of the line selected.
button again to save changes and exit set-up mode.
TDR /
Model CA7027
®
GlobalTestSupply
www.
AEMC Instruments
Fault Mapper Pro
VX.X
button, then press the
TDR
Vp % VC
Vp=67%
T/P 100Ω
Meters
Contrast
Shutdown : 1 Minute
is turned off, it will retain the
®
button to enter
TEST /
.com
sales@GlobalTestSupp
,
9