Install The Fabric Stack - Kirsch Cellular Shade Collection Getting Started

Install the Fabric Stack

NOTE: The installation procedures that follow are the same for inside and outside mounts, except where indicated.
Prepare the Fabric Stack
Insert the stationary rail bracket into the vertical rail on the side where the fabric stacks.
■ ■
The bracket fits into the grooves on the rear of the vertical rail.
➤ ■
Insert the bracket until it is seated and the bracket catch snaps into the hole on the back of the rail. Check that the bracket
➤ ■
catch is fully engaged.
Seated Bracket
Insert the stationary rail bottom bracket into the bottom of the stationary rail.
■ ■
The bracket fits into grooves at the bottom of the rail.
➤ ■
Insert the bracket with the mounting flanges to the back, away from the fabric stack as shown. Do not seat the bracket;
➤ ■
about ⁄ " should extend from the rail.
1
4
After inserting the bracket, peel off the red label.
➤ ■
Insert Bracket
into Grooves
Insert Bracket
into Grooves
INSTALLATION
INSTALLATION
Continue to
Slide Bracket
Bracket Catch
7