Kirsch Cellular Shade Collection Getting Started page 24

Problem Batteries in the battery wand need to be replaced.
Solution Replace the batteries in the battery wand.
Squeeze the cap latch to release the cap and remove the cap from
the battery wand.
Install the batteries according to the instructions on the battery
wand label.
Press the cap on until it latches.
®
NOTE: Kirsch
battery-powered shades. These will provide more than one year of
operation, depending on usage. Lithium and rechargeable batteries
are not recommended.
Problem The shade binds or moves with difficulty toward the end of the headrail.
Solution Check that the headrail and installation brackets are level and aligned. Shim the installation brackets to level
the headrail.
Check that the tension cord is routed correctly. See "Set Cord Tension" beginning on page 11.
If the shade does not slide with ease, you may need to adjust the cord tension. Slide the cord tensioner toward the
end plate to slightly decrease the tension. See "Set Cord Tension" beginning on page 11.
Problem The shade does not stay in position after operating the moving rail.
Solution If the shade does not stay in position, you may need to adjust the cord tension. Slide the cord tensioner away from
the end plate to slightly increase the tension. See "Set Cord Tension" beginning on page 11.
Problem The fabric billows out when moving the shade to the stacked (fully open) position.
Solution Increase the cord tension. Slide the cord tensioner toward the fabric stack to slightly increase the tension. See "Set
Cord Tension" beginning on page 11.
Problem The cord tensioner does not lock into place.
Solution If using a valance, place a valance bracket up against the cord tensioner to act as a stop, preventing the tensioner
from sliding.
Determine the correct location for the cord tensioner. Hold it in place and insert a small screw into the channel next
to the cord tensioner.
Problem The shade is not vertically aligned.
Solution Check that the installation brackets are level and aligned. Shim the installation brackets to level the headrail, if
necessary.
Check that the headrail is completely inserted into the installation brackets. See "Mount the Headrail" on page 5
(OB) or page 6 (IB).
Adjust the screws on the moving rail bracket. Review the adjustment procedures on page 13.
recommends AA alkaline batteries for use with our
INSTALLATION
CARE
23
Battery Wand
Squeeze Cap Latch