Valance Attachment - Kirsch Cellular Shade Collection Getting Started

Valance Attachment

Attach Valance Clips
Attach the valance clips to the headrail.
■ ■
Position the bottom of the valance clip under
➤ ■
the bottom lip of the headrail.
Rotate the valance clip up to snap it into place
➤ ■
on the top of the headrail.
Keep a minimum of 3" between the end of the
➤ ■
headrail and the valance clips.
NOTE: Use the valance clips to hold the wire from
the motor to the manual control button in place.
IMPORTANT: Be sure to avoid areas where the
headrail attaches to the installation brackets.
See the appropriate page for your type of valance:
■ ■
Aluminum Valance — Below
➤ ■
Traditional Valance — Page 20
➤ ■
Aluminum Valance
Outside mounts and non-flush inside mounts only: Use the valance corner end caps and locks to attach a return to each end
■ ■
of the valance.
Slide the valance corner end cap onto the valance. Do not hammer the end cap into the valance — the end cap will bend.
➤ ■
Slide the valance return onto the corner end cap.
➤ ■
Corner End Cap
Locks
Place locks into the circular opening of the valance corner end cap with the prongs facing out.
➤ ■
Use a flat blade screwdriver to turn each lock so that its tab fits into the groove on the valance and return. This locks the
➤ ■
valance and return to the end cap.
Tab
Turn
INSTALLATION
VALANCE INSTALLATION
Headrail
19
Valance
Clip
Tabs in
Grooves