Kirsch Cellular Shade Collection Getting Started page 14

Adjust the moving rail to vertical, if necessary. Work from the front side of the shade.
■ ■
Locate the Phillips screws on the moving rail bracket.
➤ ■
To adjust the bottom end of the moving rail to the right, loosen the right screw one-half turn, then tighten the left screw
➤ ■
one-half turn. Repeat until the rail is properly aligned.
To adjust the bottom end of the moving rail to the left, loosen the left screw one-half turn, then tighten the right screw
➤ ■
one-half turn. Repeat until the rail is properly aligned.
IMPORTANT: After making the adjustments, check to be sure both screws are tight on the moving rail bracket.
Le Stack
Tension the cord.
■ ■
IMPORTANT: When the cord is properly tensioned, the moving rail slides easily yet holds its position anywhere along its travel.
Slide the cord tensioner along its channel in the headrail until the cord is taut.
➤ ■
Manually open and close the fabric stack several times. This evenly distributes tension throughout the shade.
➤ ■
If necessary, readjust the cord tensioner by sliding it until the cord is taut. Check to ensure the proper tension. Make any
➤ ■
needed adjustments by sliding the cord tensioner in its channel so that the moving rail slides easily and holds its position
anywhere along its travel.
INSTALLATION
INSTALLATION
Right Stack
= Tighten
= Loosen
13