Removing The Shade, If Necessary; Cleaning Procedures - Kirsch Cellular Shade Collection Getting Started

Problem A fabric carrier needs to be reattached.
Solution Place the carrier between the fabric cells.
Push the pin through the hole in the fabric cells.
Snap the hole at the bottom of the fabric carrier onto the pin.

Removing the Shade, If Necessary

You will need two people to remove the shade.
Detach the stationary rail bottom bracket from the wall or floor.
■ ■
Remove the valance by reversing the installation procedures.
■ ■
Hold the headrail assembly and, using a small flat blade screwdriver, push back on
■ ■
the bottom tab of the installation brackets to release the headrail.
NOTE: Because the bracket may be stiff, the headrail may be difficult to remove.
Twist the screwdriver blade slightly as you push back the bottom tab to help
remove the headrail from the bracket. Be careful not to scratch the finish on the
back of the headrail.
Place the entire Vertical Cellular shade assembly (headrail, vertical rails, and fabric
■ ■
panels) on thefloor.
To remove the fabric panels from the headrail for cleaning, reverse the steps
■ ■
stated in "Install the Fabric Stack" on page 7.

Cleaning Procedures

®
Kirsch Vertical Cellular Shades are made of anti-static, dust-resistant fabric which repels dirt and dust. For most cellular fabrics,
the following cleaning options are available.
Dusting
Regular light dusting with a feather duster is all the cleaning that is needed in most circumstances.
■ ■
Vacuuming
CAUTION: Do not vacuum Oceanside fabrics.
For deeper cleaning, vacuum gently with a brush attachment.
■ ■
Compressed Air/Hair Dryer (Cool Setting)
Use compressed air or a hair-dryer on a cool setting to blow dust and dirt off shades.
■ ■
INSTALLATION
CARE
24
Fabric Carrier
Pin