Install the Shade ............................................................................................................................................................ 6
Adjust the Tension, If Necessary.................................................................................................................................. 6
Operate the Shade ........................................................................................................................................................ 7
Removing the Shade, If Necessary .............................................................................................................................. 8
Cellular Shade Collection Cordless Side Lights Shades GETTING STARTED Product View ................................. 1 Tools and Fasteners Needed ............................2 INSTALLATION Installation Overview ..............................2 Mount the Specialty Brackets — Inside Mount ......................3 Mount the Specialty Brackets — Outside Mount ...................... 4 Install the Shade ................................
GETTING STARTED Product View Specialty Brackets Headrail End Cap Top Moving Rail Bottom Moving Rail Bottom Rail Not Shown: Specialty Brackets Top-Down Bottom-Up Non-Operable Note: The installation procedures for operable and non-operable sidelights are the same.
® Thank you for purchasing the Kirsch Cellular Shade Collection. With proper installation, operation, and care, your new shades will provide years of beauty and performance. Please thoroughly review this instruction booklet and the enclosed packing list before beginning the installation.
INSTALLATION INSTALLATION Mount the Specialty Brackets — Inside Mount Your order will include four specialty brackets. ■ ■ Specialty Bracket Bracket Template Tabs Double-sided Tape Bend the two tabs of the bracket templates downward and insert the tabs into the holes in the headrail and bottom rail as ■...
INSTALLATION INSTALLATION Mount the Specialty Brackets — Outside Mount Your order will include four specialty brackets. ■ ■ Center the headrail over the window opening at the desired height. Use a pencil to lightly mark each end of the headrail. ■...
Page 6
INSTALLATION INSTALLATION If using spacer blocks with specialty brackets, attach the spacer block(s) and specialty bracket to a flat vertical mounting ■ ■ surface with #6 mounting screws long enough for a secure installation. CAUTION: The rear spacer block must be flush against a flat mounting surface. Do not mount spacer blocks and specialty brackets on curved molding.
Front INSTALLATION INSTALLATION Headrail Bracket Bracket tabs must Install the Shade be on top of Latch Rail rubber flap Install the shade into the specialty brackets. Spring Tab ■ ■ IMPORTANT: Install the headrail into the brackets first, then install the bottom rail. Front Bottom Rail Bracket tabs must...
INSTALLATION INSTALLATION Lift the bottom rail to locate the two pockets on the underside of the rail. ■ ■ NOTE: Side light shades that are 4" to 7 ⁄ " wide only have one pocket. Fully insert the ⁄ " rail adjust key into the pocket. The key is fully inserted when the ■...
Rail Bracket Cleaning Procedures ® Kirsch Cellular Shades are made of anti-static, dust-resistant fabric which repels dirt and dust. For most cellular fabrics, the following cleaning options are available. Dusting Regular light dusting with a feather duster is all the cleaning that is needed in most circumstances.
Page 10
INSTALLATION CARE Spot-Cleaning CAUTION: Do not spot-clean Harmony, Naturelle, Oceanside, and Sonora fabrics. Prepare a solution of warm water and a mild detergent. ■ ■ Dampen a clean cloth in the solution and wring it out. ■ ■ Dab the spot with the dampened cloth until it is removed. Do not rub the fabric. ■...
Need help?
Do you have a question about the Cellular Shade and is the answer not in the manual?
Questions and answers