Battery - BRP Can-Am Ryker 900 ACE (Rally Edition) 2019 Operator's Manual

WARNING
The brake pedal requires an ad-
justment each time the RH footpeg
is moved.
To keep brakes in good condition,
check the following as per the
TENANCE SCHEDULE
– Entire brake system for fluid leaks
– Brake pedal for spongy feel
– Brake discs for excessive wear and
surface condition
– Brake pads for wear, damage or
looseness.
See an authorized Can-Am On-Road
dealer if there are any problems with
the brake system or for servicing.
Have the brake system servicing by an
authorized Can-Am On-Road dealer, a
repair shop, or a person of your own
choosing.

Battery

Battery Location
The battery is located in the front por-
tion of the vehicle, under the front ser-
vice cover.
219001998-062
Battery Charging
The vehicle is equipped with a main-
tenance-free type battery and is com-
pletely sealed; there is no need to add
water to adjust the electrolyte level.
MAIN-
:
______________
MAINTENANCE PROCEDURES
The battery may need to be charged if
the vehicle has not been ridden for at
least one month.
WARNING
Do not use conventional lead-acid
type batteries. Acid may leak out
through the battery vent of a con-
ventional lead-acid type battery.
Acid may also leak if the battery
case is cracked or damaged, which
can cause severe burns.
The battery can be charged while it is
installed on the vehicle.
NOTICE
Follow the instructions
provided with your battery charger.
Improper charging may damage the
battery.
To charge the battery, proceed as fol-
lows:
1. Remove the front service cover.
2. Remove the rubber insulator from
the positive battery terminal.
3. First connect the RED (+) cable to
the corresponding terminal.
4. Connect the BLACK (-) cable to the
corresponding terminal.
NOTICE
Always connect the RED
(+) cable first to avoid damaging the
electrical system of the vehicle.
219001998-063
1. BLACK (-) terminal
2. RED (+) terminal
111