BRP Can-Am Ryker 900 ACE (Rally Edition) 2019 Operator's Manual page 115

219001998-093
TYPICAL - HEADLIGHT REFLECTION ON
TEST SURFACE
A. Line A
B. Line B
All Other Countries
1. Verify tires are correctly inflated.
TIRE LABEL
See the
the right side service cover.
2. Position the vehicle at 10 m (33 ft)
from a test surface.
Make sure the vehicle is level and po-
sitioned perpendicularly with the test
surface.
219001998-095
TYPICAL
A. 10 m (33 ft)
219001998-096
TYPICAL
3. Trace 4 lines parallel with the ground
on the test surface as per the follow
table:
A
B
located inside
A
90°
90°
______________
MAINTENANCE PROCEDURES
LINES ON THE TEST SURFACE
(ABOVE THE GROUND)
Line A
Line B
Ryker
600
Line C
Line D
Line A
Line B
Ryker
900
Line C
Line D
Line A
Ryker
Line B
900
Rally
Line C
edition
Line D
4. Select HIGH beam.
5. Beam aiming is correct when the
focus point (brightest spot) of the
headlight reflection is between the
lines A and B.
219001998-093
TYPICAL - HEADLIGHT REFLECTION ON
TEST SURFACE
Line A
Line B
6. Select LOW beam.
7. Beam aiming is correct when the
focus point (brightest spot) of the
headlight reflection is between the
lines C and D.
486 mm (19.134 in)
449 mm (17.677 in)
517 mm (20.354 in)
466 mm (18.346 in)
481 mm (18.937 in)
443 mm (17.441 in)
511 mm (20.118 in)
461 mm (18.15 in)
466 mm (18.346 in)
429 mm (16.89 in)
497 mm (19.567 in)
446 mm (17.559 in)
A
B
113