BRP Can-Am Ryker 900 ACE (Rally Edition) 2019 Operator's Manual page 108

MAINTENANCE PROCEDURES
3.2 Using a long 8 mm Allen key
remove the fill plug.
219001998-101
4. Check oil level. The oil should be
level with the bottom of the oil level
hole.
NOTICE
Operating the final drive
with an improper oil level may se-
verely damage it.
5. If required, add recommended final
drive oil.
6. Install and tighten the fill plug.
TIGHTENING TORQUE
Fill plug
(142 lbf•in ± 27 lbf•in)
Replacing the Final Drive Oil
1. Position vehicle on a level surface.
2. From underneath of the final drive
housing, clean magnetic drain plug
area.
3. Place a drain pan under the mag-
netic drain plug area.
4. Remove the final drive oil drain plug
and the O-ring. Discard the O-ring.
CAUTION The final drive oil
can be hot.
______________
106
16 N•m ± 3 N•m
219001998-102
5. Remove the fill plug.
219001998-101
6. Allow oil to completely flow out of
the final drive.
7. Clean magnetic drain plug and pay
attention to any debris present on
drain plug.
NOTE: Presence of excessive debris
provides an indication of a final drive
problem.
8. Reinstall magnetic drain plug with a
NEW O-ring and tighten to specifi-
cation.
TIGHTENING TORQUE
Magnetic
drain plug
9. Fill the final drive through the fill
hole until the oil reaches the bottom
of the oil level hole.
10. Install and tighten the fill plug.
16 N•m ± 3 N•m
(142 lbf•in ± 27 lbf•in)