BRP Can-Am Ryker 900 ACE (Rally Edition) 2019 Operator's Manual page 125

ENGINE LACKS ACCELERATION OR
POWER (cont'd)
5. Drive belt worn too thin.
– Replace drive belt. — If the drive
belt has lost more than 3 mm (1/8
in) of its original width, it will af-
fect vehicle performance.
6. Lack of fuel
– Dirty or clogged fuel pump pre-fil-
ter. Communicate with an autho-
rized Can-Am On-Road dealer, re-
pair shop, or person of your own
choosing for an inspection and re-
pair.
7. The passenger sensor connector
is disconnected.
– Reconnect the sensor properly.
8. If a passenger's seat kit is in-
stalled, the left footpeg may be
lowered.
– Raise and close the left passen-
ger's footpeg.
ENGINE OVERHEATS
1. Low coolant level in cooling sys-
tem.
– Check coolant level and refill.
See MAINTENANCE PROCE-
DURES. Seek service from an au-
thorized Can-Am On-Road dealer,
repair shop, or person of your
own choosing for maintenance,
repair, or replacement. For US
and Canadian citizens, please
refer to the US EPA EMISSION
PERFORMANCE
contained in the WARRANTY
section for information about
warranty claims.
2. Cooling fan is not working.
– Ensure cooling fan is not jammed
and working properly.
– Check fan fuse. See FUSE LO-
CATIONS in the ROAD SIDE RE-
PAIRS section.
WARRANTY
______________
ENGINE OVERHEATS (cont'd)
3. Dirty radiators fins.
– Check and clean radiator fins.
See CLEANING THE RADIA-
TOR FINS in the MAINTENANCE
PROCEDURES section.
DIAGNOSTIC GUIDELINES
123