BRP Can-Am Ryker 900 ACE (Rally Edition) 2019 Operator's Manual page 112

MAINTENANCE PROCEDURES
Check the brake fluid level as follows:
1. Park the vehicle on a firm, level sur-
face.
2. Slide the RH footpeg in order to be
able to see the level marks on the
rear of the master cylinder reservoir.
DRIVER'S FOOTPEGS
Refer to
AND BRAKE PEDAL
3. Check the brake fluid level in the
reservoir. In both chambers, the
fluid must be above the MIN mark.
219001998-060
1. Brake fluid MIN. level mark
2. Brake fluid MAX. level mark
4. Add fluid as required. Refer to
ADDING BRAKE FLUID
NOTE: Low brake fluid may indicate
leaks or worn brake pads. See an au-
thorized Can-Am On-Road dealer.
Adding Brake Fluid
1. Slide the RH footpeg fully rearward.
2. Clean the filler cap and the top of the
reservoir.
WARNING
Clean the filler cap and its sur-
rounding area before removing
it in order to avoid brake fluid sys-
tem contamination.
3. Remove the filler cap, the anti fric-
tion washer and the diaphragm.
______________
110
section.
2
1
.
219001998-061
219001998-111
1. Filler cap
2. Anti friction washer
3. Diaphragm
4. Add fluid to MAX level.
NOTE: Replacing brake pads will in-
crease brake fluid level. If replaced
when at MAX level, brake fluid spills
may occur.
NOTICE
Brake fluid can damage
painted surfaces or plastic parts.
Wipe up any spills.
5. Reinstall the filler cap, the anti fric-
tion washer and the diaphragm.
6. Reposition the footpeg and the
brake pedal as described in the
DRIVER'S FOOTPEGS AND BRAKE
PEDAL
section.
Verifying the Brake System
The front and rear brakes are hydraulic
disc types. These brakes are self- ad-
justing and do not require adjustment.