BRP Can-Am Ryker 900 ACE (Rally Edition) 2019 Operator's Manual page 104

MAINTENANCE PROCEDURES
mmr2011-070-007_a
1. Oil filter cover screws
2. Oil filter cover
3. O-ring (discard)
4. Oil filter
12. Check the oil filter inlet and outlet
orifices inside oil filter cavity (inte-
grated part of magneto cover) for
dirt and contaminations.
mmr2011-070-008_a
1. Oil inlet orifice from the oil pressure pump
2. Oil outlet orifice to the engine lubrication
system
3. Oil filter receptacle
13. Replace the cover O-ring by a
NEW one.
14. Remove the oil filter
15. Install the NEW oil filter into the
cover.
16. Apply engine oil on O-ring and on
end of filter.
17. Insert the oil filter in its location.
NOTICE
Pay attention to avoid
pinching the O-ring during filter and
cover installation.
______________
102
18. Tighten oil filter cover to recom-
mended specification.
TIGHTENING TORQUE
Oil filter cover
screws
19. Wipe off any oil spillage on engine.
20. Install NEW sealing washers on oil
drain plugs.
NOTICE
Never
washer a second time. Always re-
place with a new one.
21. Install drain plugs and tighten to
the specified torque.
TIGHTENING TORQUE
Magnetic
drain plug
Secondary
drain plug
RTXM-2MY19-003-007_a
900 ACE ENGINE SHOWN
1. Magnetic drain plug
2. NEW Sealing washer
3. Secondary drain plug
4. NEW Sealing washer
22. Refill oil tank at the proper level
with the recommended oil.
9 N•m ± 1 N•m
(80 lbf•in ± 9 lbf•in)
use a sealing
30 N•m ± 3 N•m
(22 lbf•ft ± 2 lbf•ft)
15 N•m ± 2 N•m
(133 lbf•in ± 18 lbf•in)