GLP impression FR1 TM User Manual page 5

German Light Products®
• If you have questions about the safe installation, operation or maintenance of the
impression FR1 TM, please contact an authorized GLP distributor (see list of distributors
at www.glp.de).
• Use the luminaire only as directed in this user manual. Observe all markings in this user
manual and on the luminaire.
• Refer any service operation not described in this manual and refer all repairs to a
technician authorized by GLP.
• The light source in this luminaire must not be changed by the end user.
• Read and follow the user documentation for all additional equipment.
Electrical safety
• Do not allow the luminaire to come into contact with water or moisture.
• Install the luminaire on EUTRAC 3 lighting track that is correctly and safely installed in
accordance with the lighting track's user documentation and with local building and
electrical codes. The lighting track must be electrically connected to ground (earth)
and the installation must have both overload and ground fault (earth fault)
protection. The track must be in perfect condition and be rated for the electrical
requirements of all devices mounted on it. For more information, see the lighting track
manufacturer's documentation.
• The lighting track must be connected to AC mains power at 100-240 V, 50/60 Hz. Do
not mount the luminaire on lighting track that is supplied with power from a dimmer or
presence detector.
• Shut down and lock out AC mains power to the lighting track before carrying out any
installation or maintenance work.
• Shut down power to the lighting track when the luminaire is not in use.
• Shut down power to the lighting track immediately if the track, luminaire or any seal,
cover, cable, or other component is damaged, defective, deformed, wet or showing
signs of overheating. Do not reapply power until the item has been repaired and
made safe by a qualified technician authorized by GLP.
• If a fuse blows, replace it with one of the original type and rating only. If new fuses
blow, disconnect the luminaire from power and send it to a technician authorized by
GLP for repair.
impression® FR1 TM User Manual 5