GLP impression FR1 TM User Manual page 20

www.glp.de
If the luminaires are set up with any existing network connections, delete them by
pressing and holding the wireless linking button on the side of the luminaire for
around 10 seconds. The luminaire is now ready for a new connection.
Put the CRMX transmitter into discovery mode following the instructions in the
transmitter's user documentation. The transmitter will now search for unlinked
luminaires for a limited period.
To link one or more impression FR1 TM luminaires to the transmitter, press the wireless
linking button on the side of the luminaire(s) once. As soon the button is pressed the
luminaire will try to connect to any CRMX transmitter that is within range and in
discovery mode.
If a handshake between a luminaire and a transmitter is successful and a connection is
established, the connection is stored in both the luminaire and the transmitter. The
luminaire and transmitter will remember the connection after a power cycle.
It is normally a good idea to delete any connections that are stored in a transmitter
before starting new linking processes. Deleting stored connections will help to ensure a
clean new installation.
Unlinking and linking luminaires
You can unlink a luminaire from a CRMX network at any time by pressing the wireless
linking button on the side of the luminaire and holding for around 10 seconds.
You can link an unlinked luminaire to a CRMX Network at any time by putting the
transmitter into discovery mode and pressing the wireless linking button on the side of
the luminaire once. The luminaire will then connect to the transmitter automatically. If
the luminaire fails to connect, press the wireless linking button for about 10 seconds to
delete any stored links, and then try the procedure again.
Advice and assistance
If you would like advice with planning or implementing a DMX control system over
Lumenradio CRMX, your GLP supplier will be happy to help.
20 impression® FR1 TM
User Manual