GE Amersham Imager 600 Operating Instructions Manual page 77

Step
1
2
3
4
Connect to a Static IP network
Follow the instructions below, to connect to a Static IP network:
Step
1
Amersham Imager 600 Operating Instructions 29-0645-17 AD
Action
Connect the network cable to the Ethernet port on Amersham Imager 600.
Check the DHCP radio button in the Network window.
If desired, check the Workgroup field and use the keypad to enter the
workgroup.
Note:
For detailed information on how to use the keypad, see
page 56.
Select OK.
Result: An automatic connection to the DHCP network is established within
a couple of seconds.
Tip:
Reserve the IP address to Amersham Imager 600 for easier access of its net-
work resources.
Action
Connect the network cable to the Ethernet port on Amersham Imager 600.
4 Installation
4.4 Network
4.4.1 Network setup
Keypad view, on
77