DAKOTA ULTRASONICS MMX-7 Operation Manual page 77

The user may have transferred grid templates from a PC to the MMX-7, or setup
grids using the MMX-7 at an earlier time. The name of the currently active grid is
always displayed at the bottom of the Hot Menu Items in measurement mode (refer
to photo below). It's not o nly important to recognize what grid is currently active, but
also be able to change the active grid at any time. The following procedures outline
this process:
1) Press the MENU key once to activate the menu items tab. Press the MENU
key multiple times to tab right and the ESC key multiple times to tab left until
the DATA menu is highlighted and displaying the submenu items.
2) Use the UP and DOWN arrow keys to scroll through the sub menu items
until OPEN is highlighted.
3) Press the ENTER key to display the Grid List Box.
4) Use the UP and DOWN arrow keys to scroll through the grids until the target
grid is highlighted.
MMX-7 Data Logging Ultrasonic Thickness Gauge
Changing the Active Grid
73