Handling And Use; Switching The Appliance On/Off; Air Outlet Valve - Silvercrest SLE 320 C4 Operating Instructions Manual

Handling and use

This section provides you with important information on handling and using the
appliance.
Switching the appliance on/off
♦ Press the STAND-BY button
You will hear a beep, and the OPERATION LED
♦ Press the STAND-BY button
You will hear a beep, and the OPERATION LED
NOTE
► The appliance always starts up with the last-selected setting.
► If the appliance shuts down due to a power failure, it will automatically
restart with the last–selected setting when power is restored.
♦ If a timer has been programmed, the appliance switches off permanently
after the specified time has elapsed (1–24 hours).
♦ If the relative humidity value has been set in the TARGET HUMIDITY
program, the appliance switches off as soon as the value is reached. If the
value is exceeded, the appliance switches back on again.
♦ When the water tank
continues to run for approx. 3 minutes and then switches off. If the water
tank
lights up and the LED panel
will also beep for approx. 20 seconds.
NOTE
► The water tank
wise the condensation water cannot be properly collected.

Air outlet valve

washing, for example. In this way, you can direct the air flow towards the wet
laundry.
■ 12 │ GB │ IE │ NI
is full or removed, dehumidification stops. The fan
has been removed or is not correctly inserted, the TANK FULL LED
must be completely inserted into the appliance, other-
On the top of the appliance there is an adjustable
flap on the air outlet, which you must open during
operation. You can adjust the flap
and thus determine the direction of the air flow. This
can be helpful if you are using the appliance to dry
to turn on the appliance.
lights up continuously.
to turn off the appliance.
starts flashing.
flashes red. If switched on, the appliance
to different angles
SLE 320 C4