Handling and operation
In this section, you will receive important information pertaining to appliance
handling and operation.
Switching the appliance on/off
♦
Press the STANDBY button
LED
♦
Press the STANDBY button
LED
NOTE
►
The appliance starts in the mode last selected.
►
After a power failure, if the appliance is disconnected from the mains, or
after switching off owing to the overheating guard, the appliance starts in
the mode last selected.
♦
If a timer has been programmed, the appliance switches off defi nitively
upon lapse of the time specifi ed (1-24 hour/s).
♦
If the relative humidity value has been defi ned in the TARGET HUMIDITY
programme, the appliance switches off once the value has been attained.
If the value is exceeded, the appliance switches on again.
♦
The appliance switches off if the water tank
If wrongly positioned, or if the water tank
FULL LED
signal is emitted.
NOTE
►
The water tank
condensate cannot be collected properly.
Air outlet valve
Always open the air outlet valve, regardless of the appliance's respective pro-
gramme. If the valve is not opened, the overheating guard switches the appli-
ance off after some time for approx. 3 minutes.
SLE 320 A1
21
lights up.
20
21
20
goes out.
lights up when the appliance is switched on and an audible
19
must be fully inserted in the appliance; otherwise, the
5
to switch the appliance on. The OPERATION
to switch the appliance off . The OPERATION
is full or has been removed.
5
5
has been removed, the TANK
GB
11