Table of Contents
Advertisement
52
www.electrolux.com
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
12.11 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or op‐
erate the oven.
The oven does not heat
up.
The top lamp
1. Turn the lamp glass cover to remove
2. Remove the metal ring and clean the
3. Replace the lamp with a suitable 300
4. Attach the metal ring to the glass
5. Install the glass cover.
The side lamp
1. Remove the left shelf support to get
2. Use a Torx 20 screwdriver to remove
3. Remove and clean the metal frame
4. Replace the lamp with a suitable 300
5. Install the metal frame and the seal.
6. Install the left shelf support.
Possible cause
The oven is not connected
to an electrical supply or it
is connected incorrectly.
The oven is turned off.
it.
glass cover.
°C heat-resistant lamp.
cover.
access to the lamp.
the cover.
and the seal.
°C heat-resistant lamp.
Tighten the screws.
Remedy
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
Turn on the oven.
Advertisement
Table of Contents
