Table of Contents
Advertisement
10
www.electrolux.com
5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories
before the first use.
Put the accessories and the removable
shelf supports back to their initial
position.
5.2 First Connection
When you connect the oven to the mains
or after the power cut, you have to set
Water hardness
Class
1
2
3
4
When the water hardness exceeds the
values in the table, fill the water drawer
with bottled water.
1. Take the 4 colour change strip
supplied with the steam set in the
oven.
2. Put all the reaction zones of the strip
into the water for approximately 1
second.
Do not put the strip into the running
water.
3. Shake the strip to remove the excess
of the water.
4. Wait 1 minute and check the water
hardness with the table below.
The colours of the reaction zones
continue to change. Do not check the
water hardness later than 1 minute
after test.
Calcium deposit
(mmol/l)
dH
0 - 7
0 - 1.3
7 - 14
1.3 - 2.5
14 - 21
2.5 - 3.8
over 21
over 3.8
the language, the display contrast, the
display brightness and the time of the
day.
1. Press
or
2. Press
to confirm.
5.3 Setting the water hardness
The table below shows the water
hardness range (dH) with the
corresponding Calcium deposit and the
quality of the water.
Calcium deposit
(mg/l)
0 - 50
50 - 100
100 - 150
over 150
5. Set the water hardness: menu: Basic
Settings.
Test strip
You can change the water hardness in
the menu: Basic Settings / Water
hardness.
to set the value.
Water clas‐
sification
Soft
Moderately
hard
Hard
Very hard
Water hardness
1
2
3
4
Advertisement
Table of Contents
