Table of Contents
Advertisement
9
10
8
18
17
14
13
13
13.1
WARNING!
In clamping phase, make sure the clamps have been correctly positioned on the rim, so
preventing the wheel from falling off.
1) Set the mobile control unit in position B (Fig. B/8, page 13)
2) Tilt the tool holder to rest position (14, fig. D)
3) Use the joystick to move the chuck leftwards until there's place enough to let the wheel be set on the
platform. Keep the wheel in vertical position.
A
WARNING!
This operation can be extremely dangerous. Do it manually only if you are certain you can keep the
wheel balanced. Heavy tyres (over 110kg) and/or oversize tyres (with diameter over 130cm) shall
never be lifted by hand. Let them roll on floor and lift them by means of an adequate mechanical
lifting device.
19
D
USE
WHEEL CLAMPING
17
Advertisement
Table of Contents
