Table of Contents
Advertisement
A
B
D
C
B/8
8
A
18
17
14
D
11
Diagram B/8 shows the several working positions (A, B, C, D) that will be described in the following pages. Working
from these positions ensures greater precision, higher speed and safety level to the operator
CHECK OF CORRECT OPERATION
12
Before using the tyre-changer, some checks shall be made to grant correct operation.
ATTENTION: perform the following checks keeping the tool hold-arm (14) in "rest position".
1) Move the joystick (2, Fig. C page 9) UP (pos. F): the tool holder (14, Fig. D) must tilt to "rest position".
ATTENTION!!
Don't keep your face close to the tool holder during tilting operation.
Move the joystick (2, Fig. C page 9) DOWN (pos. G): the tool holder (14, Fig. D) must tilt and hook into "work
position".
Move the joystick leftwards (pos. H): tools must rotate by 180° on their axle counterclockwise; move the joystick
rightwards (pos. I): tools must reverse rotation and go back to initial position.
2) With tool holder in "rest position", move the switch lever (6, Fig. C page 9) UP (pos. R): the chuck holder (8, Fig.
A) must move upwards; move the switch lever DOWN (pos. S): the chuck holder must move downwards;
WORKING POSITION
15
Advertisement
Table of Contents
