Table of Contents
Advertisement
In matrix mode, any operations are unavailable except signal selection, bank selection, alpha time and black
scene setting.
Default source 1 to monitor 1, source 2 to monitor 2, and so on. Select the signal, and drag it to the source that
will set. For example, set signal 8 for source 5, as shown in the figure below:
Note: Click the monitor (the border of the monitor will turn to red), then double click the signal (the border of
the monitor will turn to yellow), the signal will be switched to the monitor.
Source 5 will be switched to signal 8, click source 1, then click "Take" icon
, the signal will be
switched to the corresponding monitor. Connect the signal to the corresponding output after setting.
Preview Mode
Click the "Preview Mode", and pop-up window as follows:
Click "OK", the system will synchronize the data, and it will finish about 5 seconds later, click "OK", it will enter
the interface as follows:
32
Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen, Fujian Province, P.R.C
Tel: 00865925771197
Fax: 00865925788216
Email: sales@rgblink.com
http://www.rgblink.cn
Advertisement
Table of Contents
