Table of Contents
Advertisement
Maintenance and Upgrade
Warning
Statement 1074—Comply with Local and National Electrical Codes
Installation of the equipment must comply with local and national electrical codes.
Step 1
Remove the drive that you are replacing:
a) Press the release button on the face of the drive tray.
b) Grasp and open the ejector lever and then pull the drive tray out of the slot.
Figure 32: Remove the Drive
1
Ejector handle
Step 2
Remove the four drive-tray screws that secure the drive to the tray and then lift the drive out of the tray.
2
Release button
Cisco AMP PC3000 Hardware Installation Guide
Remove and Replace a Drive
35
Advertisement
Table of Contents
