Cisco AMP PC3000 Hardware Installation Manual page 35

Mount the Chassis
Warning
Statement 1051—Laser Radiation
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments.
Warning Statement 1053—Class 1M Laser Radiation
Class 1M laser radiation when open. Do not view directly with optical instruments.
Step 1 Connect one Cisco-supported SFP+ transceiver and cable to the far left SFP port in PCIe 3 (see
8). This is eth0 used to manage the PC3000 through the Opadmin console and should connect to a secure management
network.
Each Cisco-certified SFP+ transceiver has an internal serial EEPROM that is encoded with security information. This
encoding allows us to identify and validate that the SFP transceiver meets the requirements for the AMP PC3000
chassis.
Note Only Cisco certified SFP+ transceivers are compatible with the 10-G interfaces and both transceivers must
be 1-G or 10-G. You cannot use one transceiver of each kind. Cisco TAC may refuse support for any
interoperability problems that result from using an untested third-party SFP+ transceiver.
Figure 31: Cable Connections
1 eth0 Private Cloud Administration Portal
interface
10 Gigabit Ethernet SFP+ support
Use only Cisco supported SFP+ transceivers.
USB 3.0 Type A port
3
You can connect a keyboard, and along with
a monitor on the VGA port, you can access the
CIMC.
Connect Cables, Turn on Power, and Verify Connectivity
2 eth1 AMP for Endpoints console interface
10 Gigabit Ethernet SFP+ support
Use only Cisco supported SFP+ transceivers.
VGA video port (DB-15 connector)
4
Cisco AMP PC3000 Hardware Installation Guide
Rear Panel, on page
31