Mitsubishi Electric MELSERVO J5 Series User Manual page 35

On a controller [G] [WG]
If a tuning error occurs during tuning, one-touch tuning is stopped. At this time, an error code is sent to [One-touch tuning
Error Code (Obj. 2D54h)]. Check the cause of the tuning error. When performing the one-touch tuning again, stop the servo
motor once. In addition, perform the one-touch tuning after the moving part is returned to the tuning start position.
Refer to the following for the causes of one-touch tuning error occurrence, and the servo parameters after the error.
Page 31 On MR Configurator2
With push buttons [A]
If a tuning error occurs during the tuning, the one-touch tuning is stopped. At this time, an error code is sent to the servo
amplifier. Check the cause of the tuning error. When performing the one-touch tuning again, stop the servo motor once. In
addition, perform the one-touch tuning after the moving part is returned to the tuning start position.
Refer to the following for the causes of one-touch tuning error occurrence, and the servo parameters after the error.
Page 31 On MR Configurator2
Stop symbol
2 s interval
*1
Error code
Pushing the "SET" button will switch to the initial screen.
Initial screen
*1 Refer to the following for the causes of one-touch tuning error occurrence, and the servo parameters after the error.
Page 31 On MR Configurator2
If an error occurs during the one-touch tuning, the tuning will be forcibly terminated and the stop
symbol and error code (C 001 to C 10F) will be displayed by turns with 2 s interval.
When performing the one-touch tuning again, stop the servo motor once.
3 ADJUSTMENT METHOD
3.2 One-touch tuning
3
33