One-Touch Tuning Stop Method - Mitsubishi Electric MELSERVO J5 Series User Manual

Servo parameter
PB46
PB47
PB48
PB49
PB51
PB52
PB53
PB54
PB55
PE41

One-touch tuning stop method

On MR Configurator2
Clicking the "Stop" button during tuning stops one-touch tuning. If one-touch tuning is stopped, "C000" will be displayed in the
error code status. After the one-touch tuning is stopped, the servo parameters are restored to the values at the start of the
one-touch tuning. When performing the one-touch tuning again, stop the servo motor once. In addition, perform the one-touch
tuning after the moving part is returned to the tuning start position.
On a controller [G] [WG]
Writing "1EA5" in [One-touch tuning Stop (Obj. 2D52h)] during the one-touch tuning stops the tuning. After the one-touch
tuning is stopped, the servo parameters are restored to the values at the start of the one-touch tuning. Moreover when
performing the one-touch tuning again, stop the servo motor once.
With push buttons [A]
Stop symbol
2 s interval
Error code
Pushing the "SET" button will switch to the initial screen.
Initial screen
3 ADJUSTMENT METHOD
30
3.2 One-touch tuning
Symbol Name
NH3 Machine resonance suppression filter 3
NHQ3 Notch shape selection 3
NH4 Machine resonance suppression filter 4
NHQ4 Notch shape selection 4
NHQ5 Notch shape selection 5
VRF21 Vibration suppression control 2 - Vibration frequency
VRF22 Vibration suppression control 2 - Resonance frequency
VRF23 Vibration suppression control 2 - Vibration frequency damping
VRF24 Vibration suppression control 2 - Resonance frequency damping
EOP3 Function selection E-3
Once the one-touch tuning mode is in progress, the one-touch tuning mode can be stopped
by pushing the "SET" button regardless of what is displayed on the screen.
The stop symbol and error code "C 000" (cancel during tuning) will be displayed by turns
with 2 s interval.
After the one-touch tuning is stopped, the servo parameters are restored to the values
at the start of the one-touch tuning.
When performing the one-touch tuning again, stop the servo motor once.