Hayward ProLogic Troubleshooting Manual page 15

How To: Clean the TurboCell (cont.)
The check system > 'Inspect Cell' message indicates that the system is recommending
the TurboCell should be inspected and cleaned (if necessary). This message will appear
every 500 operational hours as a reminder to inspect and/or clean the TurboCell.
Thoroughly Rinse Cell & Return Reset: 'Inspect Cell' message
Step 5
Step 6
1
2
3
After the solution has been safely removed, thoroughly IF the 'Inspect Cell' alarm appears, then press the
rinse the TurboCell before returning it to its place in the 'Menu' button until 'Default Menu' screen appears,
plumbing. Once returned turn the pump back ON and navigate using the (>) until 'Inspect Cell press + to reset'
proceed to the step 6. appears, then promptly press the (+) key.
NOTE: If the cell was reading a low salt level prior to cleaning, the average salt may need to be
reset. To reset the average salt level, follow the steps outlined on pg.8 or wait 24 hours for the
system to acclimate to the recent changes. For detailed instructions on resetting the 'Inspect Cell'
message, refer to pg. 12.
15