Trasmitter (Remote Control Unit) Programming; Start Button Programming; Programming Of The Button Linked To The "Lock/Aux" Output; Programming Of The Button Linkedto The On-Board Courtesy Light - King gates ELEVO Instructions And Warnings For Installation And Use

5. Trasmitter
(remote control unit)
programming
START
RADIO
SET
The transmitters to be programmed must be of the "Sty-
lo4K", "Stylo2K", DigyPad, Myo C4, NovoTX, NovoDigy series
by King Gates. See adjacent pictures.
If, at the start of the following procedures, the "set", "ra-
dio" and "error" LEDs flash, it means that the programming
protections have been activated – see Paragraph 14.1.
Therefore, radio transmitters learning is not possible.
To interrupt the following programming procedures at
any time, press the RADIO button or wait 20 seconds.
"Stylo4K"
5.1 -
This procedure allows for programming the button of the radio
control linked to the automation's start function.
5.2 -
This procedure allows for programming the button of the radio
control linked to the "Lock/AUX" output (terminals 11-12).
33
To use this function, the Lock/AUX output must be set to courtesy
light – see Paragraph 13.1.
5.3 -
This procedure allows for programming the button of the radio
control linked to the on-board led courtesy light.
To use this function, the Lock/AUX output must be set to courtesy
light – see Paragraph 13.1.
"Stylo2K"

Start button programming

STEP ACTION
PRESS THE RADIO
1
BUTTON FOR 1 SECOND
PRESS THE DESIRED
BUTTON ON EVERY
2
TRANSMITTER TO BE
PROGRAMMED
PRESS THE RADIO
BUTTON UNTIL RADIO
3 LED TURNS OFF OR WAIT
20 SECONDS TO EXIT
THE PROCEDURE
Programming of the button
linked to the "Lock/AUX"
output
STEP ACTION
RADIO
PRESS THE
1
BUTTON FOR 1 SECOND
PRESS THE START
2
BUTTON FOR 1 SECOND
PRESS THE DESIRED
BUTTON OF ALL THE
3
TRANSMITTERS TO BE
PROGRAMMED
PRESS THE RADIO
BUTTON UNTIL RADIO
4 LED TURNS OFF OR WAIT
20 SECONDS TO EXIT
THE PROCEDURE
Programming of the button linked
to the on-board courtesy light
STEP ACTION
PRESS THE RADIO
1
BUTTON FOR 1 SECOND
SET BUTTON
PRESS THE
2
FOR 1 SECOND
PRESS THE DESIRED
BUTTON OF ALL THE
3
TRANSMITTERS TO BE
PROGRAMMED
PRESS THE RADIO
BUTTON UNTIL RADIO
4 LED TURNS OFF OR WAIT
20 SECONDS TO EXIT
THE PROCEDURE
RESULT
The red "radio" LED turns
on in the fixed mode (if not,
consult Paragraph 14.1)
The red "radio" LED
flashes
The red "radio" LED turns
off
RESULT
The red "radio" LED turns
on in the fixed mode
The red "radio" LED
remains lit in fixed mode
and the red "error" LED
turns on in fixed mode
The red "radio" LED
flashes and the red "error"
LED ramins lit in fixed
mode
The red "radio" LED and
the red "error" LED turn off
RESULT
The red "radio" LED turns
on in the fixed mode
The red "radio" LED
remains lit in fixed mode
and the yellow "set" LED
turns on in fixed mode
The red "radio" LED
flashes and the yellow
"set" LED ramins lit in fixed
mode
The red "radio" LED and
the yellow "set" LED turn
off
13