Transmitter (Remote Control Unit) Programming; Start Button Programming; Programming The Button Linked To The "Lock/Aux" Output - King gates ROLLS Instructions And Warnings For Installation And Use

5.

Transmitter (remote control unit) programming

33
The transmitters to be programmed must be of the "Sty-
lo4K", "Stylo2K", DigyPad, Myo C4, NovoTX, NovoDigy series
by King Gates. See pictures below.
If, at the start of the following procedures, the "set", "ra-
dio" and "error" LEDs flash, it means that the programming
protections have been activated – see Paragraph 14.1.
Therefore, radio transmitters learning is not possible.
To interrupt the following programming procedures at
any time, press the RADIO button or wait 20 seconds.
34
"Stylo4K"
40
5.1 -
This procedure allows for programming the button of the radio con-
trol linked to the automation's start function.
5.2 -
to the "AUX" output
This procedure allows you to program the radio control connected to
the "AUX" output (output not active at the factory).
To use this function, the "AUX" output must be set to courtesy light.
"Stylo2K"

Start button programming

STEP ACTION
PRESS THE RADIO
1
BUTTON FOR 1 SECOND
PRESS THE DESIRED
BUTTON ON EVERY
2
TRANSMITTER TO BE
PROGRAMMED
PRESS TRHE RADIO
BUTTON UNTIL RADIO
3
LED TURNS OFFOR WAIT
20 SECONDS TO EXIT
THE PROCEDURE
Programming the button linked
STEP ACTION
RADIO
PRESS THE
1
TON FOR 1 SECOND
START
PRESS THE
2
TON FOR 1 SECOND
PRESS THE DESIRED
BUTTON OF ALL THE
3
TRANSMITTERS TO BE
PROGRAMMED
RADIO
PRESS THE
TON UNTIL THE RADIO
4 LED TURNS OFF OR WAIT
20 SECONDS TO EXIT
THE PROCEDURE
RESULT
The red "radio" LED
turns on in the fixed
mode (if not, consult
Paragraph 14.1)
The red "radio" LED
flashes
The red "radio" LED
turns off
RESULT
The red
BUT-
"radio" LED turns
on in the fixed mode
The red "radio" LED
remains lit in fixed
BUT-
mode and the red
"error" LED turns
on in fixed mode
The red "radio" LED
flashes and the red
"error" LED turns
on in fixed mode
BUT-
The red "radio" LED
and the red
"error" LED turn off