Installation Of Other Devices; Electrical Connections - King gates ELEVO Instructions And Warnings For Installation And Use

08. Slide the carriage until the leaf connecting bracket [N] (fig. 21)
on the upper edge of the door is perfectly perpendicular to the guide
[O].
21
09. Then secure the leaf connecting bracket [N] with rivets or screws
(fig. 21). Use screws or rivets suited to the leaf material, and ensure
that they are able to withstand the maximum force required for leaf
opening and closing.
10. Loosen the screws of the two mechanical stops, then move the
front mechanical stop [P] in front of the carriage (fig. 22).
22
Q
11. Push the carriage in the closing direction and, on reaching the
position, tighten the screw [Q] fully down.
12. Manually open the door to the required opening position, move
the rear mechanical stop [R] next to the carriage (fig. 23) and tighten
the screw [Q] fully down. Important! - Make sure the release cord
can be pulled below a height of 1.8 m.
23
R
Q
3.3 -

Installation of other devices

If other devices are needed, install them following the directions pro-
vided in the corresponding instructions. Check the devices which
can be connected to ELEVO in fig. 1 and in section 3.5 ("Description
of electrical connections").
10
3.4 -
01. Open the cover by loosening the screw (fig. 24) and pushing the
button (fig. 25).
24
O
N
25
P
02. Remove the small disc [S] with a screwdriver (fig. 26).
26
03. Feed the cables through the hole [S] (fig. 27).
27
04. Refer to fig. 28 and the connection descriptions in table 5 when
making the connections:
- if using the flashing light aerial, remove the wire clip (connected to
terminal 14 as standard) and connect the RG58 shielded cable.

Electrical connections

S
S