Advanced Programming Of The Automation's Movement; Testing And Commissioning - King gates ELEVO Instructions And Warnings For Installation And Use

6.2 - Advanced programming of the
automation's movement
With this procedure, the control unit memorizes the times and power
required for opening and closing the system.
Moreover, this procedure allows for setting:
- start point of slowdowns or their deletion.
STEP ACTION
PUT THE DOOR TO HALF
1
WAY POSITION
PRESS THE SET BUTTON
2
FOR 2 SECOND
PRESS THE RADIO
3
BUTTON FOR 1 SECOND
THE DOOR PARTIALLY
4
OPENS
THE DOOR MOVES TO
5
FULL CLOSING POSITION
PRESS THE SET BUTTON
OR A BUTTON OF A
6 PAIRED TRANSMITTER
OR CLOSE START
WIRED CONTACT
THE DOOR PERFORMS
7
THE OPENING OVEMENT
PRESS THE SET BUTTON
OR A BUTTON OF A
PAIRED TRANSMITTER
OR CLOSE START
WIRED CONTACT, TO
8 SET THE SLOWDOWN
START POINT (*). FOR
NOT HAVE SLOWDOWN,
WAIT UNTIL THE
MOVEMENT HAS BEEN
COMPLETED
THE DOOR COMPLETES
9
THE OPENING PHASE
PRESS THE SET BUTTON
OR A BUTTON OF A
10 PAIRED TRANSMITTER
OR CLOSE START
WIRED CONTACT
THE DOOR PERFORMS
11 A FULL CLOSING
MOVEMENT
DURING MOVEMENT:
PRESS THE SET BUTTON
OR A BUTTON OF A
PAIRED TRANSMIT-
TER OR CLOSE START
WIRED CONTACT
12
SET THE SLOWDOWN
START POINT (*). FOR
NOT HAVE SLOWDOWN,
WAIT UNTIL THE
MOVEMENT
HAS BEEN COMPLETED
THE DOOR COMPLETES
13
THE CLOSING PHASE
END OF THE
14 PROGRAMMING
PROCEDURE
(*) Minimum slowdown time must be 3 seconds.
16
RESULT
The yellow "set" LED
flashes (if not, consult
Paragraph 14.1)
The yellow "set" LED turns
on in the fixed mode
The yellow "set" LED stays
on
The yellow "set" LED
flashes
The yellow "set" LED stays
on
The yellow "set" LED stays
on
The yellow "set" LED stays
on
The yellow "set" LED stays
on
The yellow "set" LED stays
on
The yellow "set" LED stays
on
TO The yellow "set" LED stays
on in the fixed mode
The yellow "set" LED turns
off
The LEDs return to the
normal operation
configuration
If the "FORCE" knob is adjusted, the automation's move-
ment must be reprogrammed.
The red "Error" LED flashes during the automation's
movement when a mechanical stress point is detected (this
corresponds to increased motor effort).
Adjust OBSTACLE Adjust OBSTACLE and FORCE knobs
(slightly turn them clockwise) to solve this and check gate
mechanics if necessary.
7. Testing and
commissioning
Once the programming setup has been completed, verify that:
- the motors turn off after a few seconds once the opening or closing
phases end (also "error" LED turns off);
- the control unit responds to the connected wired commands:
"START" (terminal 7), and "STOP" (terminal 6);
- all programmed radio transmitters are operational;
- the safety devices connected to "S2 Photo" (terminal 4) intervene
while the door closes and prevent the open door from closing;
- the safety devices connected to "S1 Edge" (terminal 9) intervene
while the door opens and closes with a brief movement inversion;
If the "Func" dip-switch is put to ON, check that S2 Photo safety
devices intervene also when the door opens and that they prevent
the closed door from opening.