Adc34Jxx Tab - Texas Instruments ADC3EVM User Manual

www.ti.com
2.2.1.6 LMK04828
The registers for the LMK04828 are best described in the LMK04828 data sheet, and are not covered in
this user guide.
2.2.2 Low Level Register Control
• Send All: Sends the register configuration to all devices
• Read All: Reads register configuration from ADS58H40 device (not implemented in revision 1.x)
• Save Regs: Saves the register configuration for all devices
• Load Regs: Load a register file for all devices. Sample configuration files for common frequency plans
are located in the install directory.
– Select the Load Regs button
– Double click on the data folder
– Double click on the desired register file
– Click on Send All to ensure all the values are loaded properly
2.2.3 Misc Settings
• Reconnect FTDI: Toggle this button if the USB port is not responding. This generates a new USB
handle address
NOTE: Reset the board after every power cycle and then click the reconnect FTDI button on the GUI.
• File→Exit: Stops the program
SLAU579D – June 2014 – Revised August 2018
Submit Documentation Feedback
Figure 14. ADC34Jxx Tab
Copyright © 2014–2018, Texas Instruments Incorporated
Software Control
ADC3xxxEVM and ADC3xJxxEVM
23